The Kidde PI2000 is a 120VAC, wire-in smoke alarm with
9V battery backup. This smoke alarm functions as a stand
alone unit or in an interconnected system. The Kidde
PI2000 features Hush , allowing you to quickly silence
nuisance alarms and also includes a tamper resist features
that deters tampering and theft. The PI2000 includes a
quick connect power harness that allows for quick and
easy installation.
This smoke alarm combines both photoelectric and
ionization sensors. Ionization sensing alarms may detect
invisible fire particles (associated with flaming fires) sooner
than photoelectric alarms. Photoelectric sensing alarms
may detect visible particles (associated with smoldering
fires) sooner than ionization alarms.
Kidde strongly recommends that both ionization
and photoelectric smoke alarms be installed to help
insure maximum detection of the various types of
fire that can occur within the home.
The Kidde PI2000, 120VAC, wire-in smoke alarm
with 9V battery back up provides continuous protection
against smoke and fire hazards, even during power outages.
The combination of ionization and photoelectric
sensors offer the best protection against both fast flaming
and slow smoldering fires. The Kidde PI2000 interconnects
with up to 24 Kidde devices of which 18 can be
initiating. This unit also includes flashing LEDs to signal
the alarm is functioning properly, a low battery warning
and a loud 85dB alarm. The Kidde PI2000 is UL Listed
and includes a 10-year limited warranty.
- Ionization Sensor – may detect invisible fire
particles (associated with flaming fires) sooner
than photoelectric alarms.
- Photoelectric Sensor – may detect visible particles
(associated with smoldering fires) sooner than
ionization alarms.
- Interconnect – Interconnects with up to 24
Kidde devices on one wiring network of which
18 can be initiating.
- Battery Backup (9V battery included) – Provides
continuous protection even during power outages.
- Tamper Resistant – Deters from tampering or theft.
- Hush Feature – Temporarily silences nuisance alarms.
- Red LED – Flashes every 30-40 seconds to indicate
that the smoke alarm is operating properly.
- Test/Reset Button – Tests smoke alarm circuitry
and horn.
- Alarm Memory – Indicates the originating alarm
in an interconnected system.
|
